Berroco

fine handknitting yarns

Search

Tidbits from Berroco Design Studio, read & share ›› Go to Blog RSS

Send this page to a friend:

Isabelle

knit and felted in Hip-Hop®
Skill level: Easy

This is a knit pattern.


enlarge model

 

 

 


enlarge detail

 

Abbreviations & Terms

Yarn used ...

 

Bookmark and Share

Our felted Hip-Hop hat has a floppy brim which has been cut and rolled to form a felted rose adornment.

 

One size

 

SIZE

Approximately 24” around x 9” high after felting

 

MATERIALS

3 Hanks BERROCO HIP-HOP (100 grs), #7255 Red Spyda

16” Length circular knitting needle, size 13

1 Set double pointed knitting needles (dpn), size 13

1 St marker

Sewing needle and matching sewing thread

 

GAUGE

10 sts = 4”;  15 rnds = 4” in St st on size 13 needles before felting

TO SAVE TIME, TAKE TIME TO CHECK GAUGE

 

HAT

With circular needle, cast on 100 sts.  Join, being careful not to twist sts.  Mark for beg of rnd and carry marker up.  Work even in St st (k EVERY rnd) for 4”.

Dec Rnd 1:  * K2 tog, k3, rep from * around – 80 sts.  Work even until piece measures 10” from beg.

Note:  When decreasing, if there are too few sts to fit comfortably on circular needle, change to dpn’s.

Shape Crown:  Dec Rnd 2:  * K2 tog, k2, rep from * around – 60 sts.  Work even for 8 rnds.

Dec Rnd 3:  * K2 tog, k1, rep from * around – 40 sts.  Work even for 4 rnds.  Bind off.

 

FINISHING

Sew top seam.  Felt by washing in washing machine with hot water and soap.  Check fit often while washing.  Shape by hand and allow to air dry.

Flower:  Measure 12” along lower edge of hat and mark with pins.  Using sharp scissors, cut 2” in from edge at one pin, then cut horizontally 2” in from lower edge to second pin leaving one end attached to hat.  Roll this strip with cut end at center forming rose.  Sew to edge of hat using sewing needle and thread as in photo.  Using scissors, cut the edge of hat at first pin into a curve.