Berroco

fine handknitting yarns

Search

Tidbits from Berroco Design Studio, read & share ›› Go to Blog RSS

Send this page to a friend:

Hanne

knit in Palace®™ | color info
Skill level: Intermediate

Knit Project

enlarge model


Hannele instructions

enlarge detail

Abbreviations & Terms

 

Yarn used ...


Palace®

 

Like this pattern? You may also like these patterns from our recent booklets . . .
  

Bookmark and Share

A cozy muff done in a mock cable pattern.

 

PDF Pattern Instructions

(If you can’t open this PDF file you need Adobe Acrobat Reader. Get it here.)

One size

FINISHED MEASUREMENTS
Approximately 13” wide x 14” around

MATERIALS
2 Balls eachBERROCO PALACE (50 grs), #8903 Versailles (A) and #8953 Shanghai Blue (B)

Straight knitting needles, size 8 (5.00 mm) OR SIZE TO OBTAIN GAUGE

2 Pieces of Polyester Batting 13” x 14”

Tapestry needle

GAUGE

18 sts = 4”;  24 rows = 4” in St st

TO SAVE TIME, TAKE TIME TO CHECK GAUGE

STITCH GLOSSARY

M1R

Insert point of RH needle from back to front under strand between next 2 sts, lift this strand onto LH needle and knit it through the front loop

M1L

Insert point of RH needle from front to back under strand between next 2 sts, lift this strand onto LH needle and knit it through the back loop

DD (Double Dec)

SSK, return resulting st to LH needle, pass next st over it and off the needle, slip st back to RH needle

PATTERN STITCH

Note:  Due to the nature of this pattern, the number of sts will vary from row to row.

Row 1 (RS):  P3, * M1R, k1, M1L, p3, k5, p3, rep from * across.

Row 2 and all WS rows:  K the k sts and p the p sts as they face you

Row 3:  P3, * M1R, k3, M1l, p3, k1, DD, k1.

Row 5:  P3, * k5, p3, DD, p3, rep from * across.

Row 7:  P3, * k1, DD, k1, p3, M1R, k1, M1L, p3, rep from * across.

Row 9:  P3, * DD, p3, M1R, k3, M1l, p3, rep from * across.

Row 10: Rep Row 2.

Rep these 10 rows for Pat St.

OUTER LAYER

With straight needles, using A, cast on 75 sts.  Work even in Pat St until piece measures 14” from beg, end on WS.  Bind off.

LINING

With straight needles, using B, cast on 64 sts.  Work even in St st for 14”, end on WS.  Bind off.

FINISHING

Lay lining flat with WS facing up.  Lay outer layer on top with RS facing up.  Lining should extend about ½” out from each side edge of outer layer.  Using B, sew side edges of pieces tog.  Insert 2 layers of batting between outer layer and lining, making sure that they lie flat.  Pin bound-off and cast-on edges tog.  Lining edges will roll back to RS.  Using tapestry needle and B, insert needle from WS to RS at each DD of outer layer, then back from RS to WS.  Repeat this twice more, anchoring all the layers tog at these points.  Sew cast-on and bound-off edges tog.